The CAMIT water purification system is of a chemical-physical type and allows the purification of the water coming from industrial washing operations in order to allow it to be used again with a pressure washer. The purifier is entirely built on a structural base complete with perimeter paneling and roof, inside the block there are both the service tanks and the chemical-physical purification system.
Alternatively, the tanks are made of vibrated reinforced concrete in formwork by means of a high frequency immersion vibrator, in monolithic and watertight execution or in double-walled polyethylene.
The system is suitable for the purification of waste water from washing operations of mechanical parts and carpentry with a pressure washer and for their reuse for closed cycle washing. The clarification / sedimentation tank with a circular plan with a conical bottom is complete with a device for extracting the sludge.
Estimated storage / dosing lines:
With flocculating reagent in liquid form with tank equipped with variable flow dosing pump.
With powder adsorbent / neutralizing reagent and tank equipped with minimum level regulator, lid in stainless steel, vertical screw and guide tube in stainless steel, operated by a motor-variator unit.
An optional system with coal treatment is provided in the event that the water clarified and treated by the chemical-physical group must be introduced into the sewer system rather than being reused for new washing cycles. However, the unit can also be installed at a later time, if necessary, without particular modifications to the system.